Anchoring Adhesives Installation

Posted by Pedram Mojarrad on

 

Installing procedure when using Epoxymix Construction, Fastcure, Ultra, Rapid & Underwater products with anchors etc; into concrete and other solid masonry

Steps:

1.Drill hole to correct diameter and depth as specified for your anchor. Diamond core drill holes should be roughened prior to injection of Epoxymix
2.Clean holes with wire brush, this procedure is very important and any residue left in the hole will prevent Epoxymix bonding with the substrate
3.Attach nozzle to cartridge and discard the first 100mm of Epoxymix until the mix is in a solid colour.
4.Inject from the base of the hole, withdrawing as the hole fills up to ½ full(depending on the application)
5.Insert the fixing with a one direction twisting motion until the Epoxymix resin can be seen at the opening of the hole. Remove excess.
6.Leave uninterrupted until cured. See spec sheet of Epoxymix product for gel and curing times.

Fixing into hollow brick work

1.Procedure the same as Step 1-3 above.
2.Insert Epoxymix nylon sleeve
3.Inject Epoxymix from the base of the drill hole until the sleeve is full
4.Insert the fixing using a one direction twisting motion
5.Leave until fully cured.


See spec sheet of Epoxymix product for gel and cure times.


Share this post



← Older Post Newer Post →